Designed to Insert Anti-Walk Blocks
This CRL Anti-Walk Block Insert Tool is designed to insert the last Anti-Walk
Blocks after the glass has been centered in the opening. Simply flatten a block
against the glass near the vertical tube pocket and, using the Insert Tool, push
the block between the glass and the pocket wall. After it passes the glass edge,
it will snap back into its coil configuration, creating a positive block against
movement.
Additional Product Information:
INSTRUCTIONS: After the glass is centered in the opening, determine the space
between the edge of the glass and the bottom of the pocket. Use the Anti-Walk
Block 1/16 inch smaller than the space. Flatten out the correct size blocks and
insert them in the top and bottom of the vertical glazing pocket. Now insert
glass in the opposite vertical pocket, using standard flush glazing procedures,
pulling the glass back against the Anti-Walk Blocks that have already been
inserted. Place a flattened Anti-Walk Block next to the vertical pocket that has
no blocks already in it. Use the Insert Tool to push the block between the front
edge of the pocket and the glass.