Prevents Glass from "Walking" Out of the Glazing
Pocket
Coiled Rubber Blocks
Snaps Back Into Coiled Position
These CRL Anti-Walk Blocks are designed to prevent the glass from
"walking" out of the glazing pocket by providing a positive stop in each
vertical tube. The coiled rubber blocks can be spread out and inserted into the
storefront tube glazing pocket, after which they snap back into their coiled
position and stay in place. The AWBT Insert Tool is designed to insert the last
Anti-Walk Blocks after the glass has been centered in the opening. Simply
flatten a block against the glass near the vertical tube pocket and using the
Insert Tool, push the block between the glass and the pocket wall. After it
passes the glass edge, it will snap back into its coil configuration, creating a
positive block against movement.
Width: 7/16 in (11 mm)
Thickness: 1/8 in (3 mm)
Length: 3-7/16 in (87 mm)
Additional Product Information:
INSTRUCTIONS: After the glass is centered in the opening, determine the space
between the edge of the glass and the bottom of the pocket. Use the Anti-Walk
Block 1/16 inch (1.6 millimeter) smaller than the space. Flatten out the correct
size blocks and insert them in the top and bottom of the vertical glazing
pocket. Now insert glass in the opposite vertical pocket, using standard flush
glazing procedures, pulling the glass back against the Anti-Walk Blocks that
have already been inserted. Place a flattened Anti-Walk Block next to the
vertical pocket that has no blocks already in it. Use the Insert Tool to push
the block between the front edge of the pocket and the glass.