Please, note, these balances are made to your order; they cannot be returned for refund or credit; the lead time is approximately two to three weeks.Actual size is 17/32" (height) x 9/16" (width), but considered 1/2" x 1/2". Please, note that the 1/2" channel height is smaller than the usual 19/32" height on standard balances.
Channel Length: 26 in
Stamped Number: 26E
Vent Weight: 26 - 30 Pounds
Before ordering, make sure the length and stamped numbers on the channel being replaced match the length and stamped numbers listed above.
To complete assembly each balance is shipped with the End Bracket attached. End Bracket must be ordered separately: 60-518 or 900-18354
While each balance is packaged and sold individually, it is our recommendation that both balances in the window be replaced at the same time. This will restore the sash to a near new condition, and prolong the life of the window.
Ordering Information:
1. Measure metal channel length (do not include any attached ends).
2. Identify number stamped on channel.
3. Select our corresponding part number.
4. Identify the appropriate end bracket to be attached out of the following: 60-518 or 900-183545. End brackets must be ordered with balances to complete order. Orders for channel balances without end brackets will not be processed.
6. If the letter "T" appears after the number stamped, it indicates a top sash balance. When ordering, please, specify in comments that your original balance has "T" stamped on it.
Minimum Order: 1 Balance
Note: Old Manufacturer (Jim Walters) of this series balances stamped it with a four digit number (e.g. 2130). These balances are no longer manufactured with this stamping. To identify your balance and match up properly with the new manufacturer's balances, you must take the following steps:
1. Measure exact length of channel.
2. Identify the weight range you require. Weighing your sash is the only way to get the exact weight range required. The old balance with the four-digit number has a different weight range than the new balances. Please, give us a call at 216-663-9830 if you have any questions.
3. Select corresponding part number.
4. Identify the appropriate balance end to be attached.
"SPECIAL ORDER ITEM - NON-REFUNDABLE, NON-RETURNABLE."