Gordon Glass® 3"Satin Anodized Frameless Shower Door Pull Handle Kit
For Retrofit or New Installation
No Glass Fabrication Required
Please note: this shower door pull handle does
not include a magnet or a strike plate
Material: Aluminum
Finish: Satin Anodized
Handle Size: 3 in
Kit includes:
3" Frameless Shower Door Pull Handle
Rubber Gasket - for use with 1/4" thick glass
Clear 100% Pure RTV Silicone Sealant (0.5 oz.
Squeeze Tube) for use with 3/16" and 5/16" thick glass
Installation Instructions:
The included rubber gasket is for 1/4" glass
only;
for 3/16" or 5/16" use provided silicone
For 3/16" and 5/16" glass: Run two beads of silicone along the inside walls
of the pull handle; position and slide over the edge of the glass. Tape the
handle in place to prevent sliding and allow 24 hours to cure.
For 1/4" glass:
Place the rubber gasket over the edge of the glass on the desired area and
apply the handle over the gasket (this may require gentle tapping with a rubber
mallet).