Cuts Perfect
V-Shaped Notches in Nozzles
Safest Way to Trim V-Notches
This CRL
V-Notch Cutter is the quickest and safest way to trim your nozzles. Cutting
the proper V-Notch on a urethane cartridge nozzle can be difficult and dangerous
if you do not use the proper tool. The CRL V-Notch Cutter is a high quality tool
that comes with tempered steel jaws, a spring loaded handle with non-slip
plastic grips, and a thumb controlled jaw locking device.
Size of V-Notch: 7/16 x 3/4 in (11 x 19 mm)
Minimum Order: 1 Each
To use this tool, take a utility knife and cut the end of the nozzle tip to give
yourself a 1/4 inch (6.4 millimeter) or larger bead. Next, insert the CRL
V-Notch Cutter tool inside the nozzle. Squeeze the handle and you have a perfect
V-Notch. To correctly set the height of your V-Notch, place the nozzle (with a
pre-cut end) on the pinchweld. Mark the height of the body panel on the nozzle
and trim to that height. This will prodvide you with the proper height for
compression of the urethane bead.