For 1/2" and 3/4" (12 and 19 mm) Tempered Glass
(Not Designed for Laminated Glass Applications)
Tested and Engineered to Meet and Exceed Code Standards
Reduces Installation Time by 50%
Each TAPER-LOC™ Set Consists of Two Tapers and One L-Pressure Block
CRL's TAPER-LOC™ Taper Set for 1/2"-3/4" Glass is made up of two Tapers
and one L-Pressure Block. Tapers are made of high strength reinforced nylon.
They expand in thickness when compressed together with the Cat. No. TLK5
Installation/Removal Tool, mechanically locking the glass panel into the base
shoe. The TAPER-LOC™ L-Pressure Block is made from high strength reinforced
nylon. It spaces the glass away from the base shoe's vertical wall on one side
and at the bottom edge, and is attached to the glass panel prior to installing
into the base shoe with an adhesive tape strip that is pre-installed. It also
serves to insulate the glass panels from damage during insertion into the base
shoe and, at the same time, center the glass in the pocket.
Additional Product Information:
Glass Panel Width/Required Quantity of TAPER-LOCS
6 to 14 inches (152 to 356 mm)/ 1 Taper-Loc
14 to 28 inches (356 to 711 mm)/ 2 Taper-Locs
28 to 42 inches (711 to 1067 mm)/ 3 Taper-Locs
42 to 56 inches (1067 to 1422 mm)/ 4 Taper-Locs
56 to 70 inches (1422 to 1778 mm)/ 5 Taper-Locs
70 to 84 inches (1778 to 2134 mm)/ 6 Taper-Locs
Important Note:
Not intended to be used with laminated glass.