CRL Swivel Glass Drill Machine
C.R. Laurence CRL Swivel Glass Drill Machine | SDM4
Category: Glass Drilling Machines
CRL Swivel Glass Drill Machine
SKU: SDM4
UPC:

$2,206.87 (20% off)

$1,839.06

Product Details:

Drills Outlet Cutouts Without Repositioning
Built-In Retaining Ring

The finest machine for the mirror installer
The center of a 2x4 cut-out is marked in the base for easy and accurate alignment
Suction cup holds machine firmly in place
Built in diamond drill coolant retaining ring
Machine head pivots right to drill 1st hole, then head pivots left to drill 2nd hole
Rubber plug provided to prevent coolant leaks when drilling 2nd hole
Gear drive and adjustable nylon wear pads make maintenance a snap
1200 RPM Single Speed 7 AMP motor 120v AC
Manufacture in the USA

This unique drilling machine was designed primarily to make cutouts for plug and switch receptacles. The CRL Swivel Drill Machine has a suction cup base that also acts as a coolant retainer when drilling with Diamond Tube Drills. Drill first hole, insert rubber plug, swivel drill head and drill second hole. Can also be used for drilling larger holes with tube drills up to six inches (152.4 millimeters) in diameter. Drill head has the unique ability to swing a full 360 Degrees so drilling up close to the glass edge is made easy. This also lets you use drills larger in diameter than will fit in the built-in retaining ring.

Note:
Swivel head to the side for large holes, up to 6 inches.