CRL SPS Standard Support Assembly
C.R. Laurence CRL SPS Standard Support Assembly | 90TSS1
Category: Just Arrived!
CRL SPS Standard Support Assembly
SKU: 90TSS1
UPC:

Product Details:

  • Provides 6" (152 mm) of Vertical Adjustment
  • Ideal for Mounting to Steel I-Beams
  • Provides 'Fine-Tune' Adjustment

The SPS Standard Support Assembly is used when the mounting substrate is within 6 inches
(152 millimeters) of the top of the SPS Overhead Track. Each set consists of a steel Upper Mounting Bracket, an aluminum Lower Mounting Bracket, two 3/8 inch-16 x 6 inch (152 millimeter) long Suspension Rods, a 3/8 inch-16 x 1-1/4 inch (31.7 millimeter) Track Mounting Bolt, nine 3/8 inch-16 Hex Nuts, nine Flat Washers, and five Lock Washers.
Note: The Upper Mounting Bracket requires a single fastener (not supplied) to attach it to the substrate, or if mounting to steel, it can be welded. It can also be eliminated by attaching Suspension Rods directly to the steel substrate. Consult a structural engineer for recommendations.