Product Details:
- Angled to Provide Lateral Support
- Accommodates Up to a 40" (1016 mm) Vertical Suspension
From Structure
- Provides 'Fine-Tune' Adjustment
|
The SPS Angled Support Assembly is
used to provide lateral support when the mounting substrate is more
than 6 inches (152 millimeters) from the top of the SPS Overhead
Track. Each set consists of a steel Upper Angled Mounting Bracket,
an aluminum Lower Angled Mounting Bracket, one 3/8 inch-16 x 40
inch (1016 millimeter) long Suspension Rod, one 3/8 inch-16 x 1-1/4
inch (31.7 millimeter) Track Mounting Bolt, five 3/8 inch-16 Hex
Nuts, five Flat Washers, and two Lock Washers. The Upper Mounting
Bracket requires a single fastener (not supplied) to attach it to
the substrate, or if mounting to steel, it can be welded. Consult a
structural engineer for recommendation.
NOTE: Must be used in conjunction with
CRL Cat. No. 90TSX1 Extended
Support Assemblies to stabilize the entire SPS Overhead
Track.