For 3/8" or 1/2" (10 or 12 mm) Glass
The CRL Left Hand Sidelite Mounted Transom Patch with Support Fin Bracket
is used to support a transom from a sidelite glass panel. It comes with a INT300
Insert for mounting a door with a CRL PH20A or PH21A Top Door Patch Fitting. For
single doors, the insert can be removed on the non-hinged side allowing for a
double swinging door. A INT306 Transom Patch Door Stop Insert can be used to
create a one way door. Also, a INT305 Transom Patch Keeper Insert can be
installed for use with an AMR205 Lock when used for a top of the door
installation. The support fin glass should be sized in accordance with approved
design criteria (refer to GANA or Manufacturers Manual) and secured to the
ceiling with a PH92 Ceiling Mounted Support Fin Bracket.
Color: Polished Stainless
Minimum Order: 1 Each
Additional Product Information:
Glass Fabrication Required: Five 3/4 inch (19 millimeter) Diameter Holes and Two
Corner Notches.
Important Note:
If the weight of the transom exceeds 100 pounds (45.4 kilograms) the transom
must be supported from the ceiling. This is to prevent the Patches from slipping
from too much weight.