Curved Body
Works With 2-11/16" (68 mm) Pivot Setback Door Patch Fittings
Gaskets for use with 3/8" or 1/2" (10 or 12 mm) Glass
The CRL Curved Right Hand Sidelite Mounted
Transom Patch with Support Fin Bracket is used to support a transom from a
sidelite glass panel. It comes with a INT300 Insert for mounting a door with a
CRL PH20A or PH21A Top Door Patch Fitting. For single doors, the insert can be
removed on the non-hinged side allowing for a double swinging door. A INT306
Transom Patch Door Stop Insert can be used to create a one way door. Also, a
INT305 Transom Patch Keeper Insert can be installed for use with an AMR205 Lock
when used for a top of the door installation. The support fin glass should be
sized in accordance with approved design criteria (refer to GANA or
Manufacturers Manual) and secured to the ceiling with a PH92 Ceiling Mounted
Support Fin Bracket.
Color: Polished Stainless
Minimum Order: 1 Each
Glass Fabrication Required: Five 3/4 inch (19 millimeter) Diameter Holes and Two Corner Notches.