Product Details:

Conductive Two-Part Adhesive

Easy-to-Use System

The CRL Rear Defroster Connector Repair Kit is easy to use. Just mix equal parts of Part A Epoxy with Part B Hardener and apply with the reusable applicator stir stick.

Apply the connector tab and keep immobilized for less than 10 minutes. Full cure will be obtained in 24 hours or less depending on temperature and thickness of material.

Always use a minimal amount for fastest cures.

Contents: .05 Fl. Oz (14 g)

Important Note:

It is important that this material cure for over 24 hours 77° and above prior to applying power to the tab. Material can be heated to accelerate the cure (149° TO 248°) for 10 minutes.