Product Details:
- One Piece Construction Gives Rigidity and
Durability
- The "Old Reliable" Way to Drill Glass
|
This CRL Steel Tube Drill was designed
for use in our CRL Tripod
Drill or similar type drill machine. It works with an abrasive
grain such as CRL Silicon
Carbide Grain to "drill" holes in glass through rotational
abrasion. A coolant (or
water) is mixed with the abrasive to form a slurry which is
retained by a CRL Rubber Base
Drilling Ring. The even and steady rotation of the tube drill
against the glass will produce a clean hole with minimal breakage
or chipping. This CRL Steel Tube Drill is
the economical fulfillment of your glass drilling needs. The
all-steel welded drill measures four inches (102 millimeters) long
and it can be used down to the second set of abrasive grabbing
slots. It has a 1/4 inch (6.35 millimeter) diameter shank to fit
most machines.
Always wear the proper safety gear including eye protection when
drilling glass. Work should be performed on a flat, horizontal
surface. A Ground Fault Circuit Interrupter must be used when using
any type of electric tool in conjunction with water or coolant.
Failure to follow any of these precautions can result in operator
injury.