Meets or Exceeds U.S. Federal Motor Vehicle Safety Standards 208 and 212
Heat Accelerated Curing Provides Fast, Safe, Drive Away Times
CRL/Somaca Heated Urethane Adhesive is specially formulated as a safe, fast alternative to room temperature applied one-component urethanes. CRL/Somaca Heated Urethane accelerates the curing of the material when heated first in a Urethane Oven to provide you with fast, safe, driving release times for customers who demand their vehicle back quickly. CRL/Somaca Heated Urethane passes or exceeds U.S. Federal Motor Vehicle Safety Standards FMVSS212 (Barrier Crash Test) and FMVSS208 (Occupant Crash Protection) in its most severe interpretation with dual air bags and unrestrained dummies. The fast curing formula offers Safe Drive Away Time in as little as 30 minutes when used on vehicles without a passsenger side air bag, two hours with passenger air bag at 15°F (-9.4°C) and 25% RH (relative humidity).
Contents: 10.1 Fl Oz (300 ml)
Shelf Life: 9 Months
Additional Product Information:
Cleaning and Primers
CRL/Somaca Urethanes are supported by a one-step primer and aerosol cleaner formulated for use in all aspects of glass bonding, including the glass frit, pinchweld, and EPDM/PVC moldings.
1. After removing all of the old urethane to within 1/16 inch (1.5 millimeter) of the pinchweld, prepare the pinchweld following the procedures outlined in the CRL Technicians Training Manual. Prime these areas with 1214006 One Step Primer.
2. Clean the inside of the windshield with a lint-free towel 1550 and PWR22 Automotive Glass Cleaner.
3. Apply the same 1214006 One Step Primer to the frit area with a lint-free towel and allow to dry for a minimum of 10 minutes, but no more than 8 hours before installing the adhesive. This procedure must be performed above 40°F (4°C). NOTE: One Step Primer must be used prior to any adhesive application to prevent glass displacement. Failure to do so may result in personal injury or property damage.
4. Apply 1214006 One Step Primer to encapsulated moldings if they are part of the bonding area.
Packaged in metal cartridges with screw-on 4-1/2" (114 mm) long Cone Nozzles included in every case. 12 cartridges per case.