Amazing New Technology
Easy to Install- No Stretching, No Staples, No Spline
Durable, Safe, Versatile and Cost Effective
This new patented CRL ScreenEze™ System is an easy to install two-piece snap
design, which does not require spline or rolling tools. The base is extruded
aluminum, and the snap cap is extruded vinyl.
Simply attach the base along the
entire edge of the inside or outside perimeter of your opening. Lay your screen
wire on the face of the base angle and snap the vinyl onto one side. then pull
the wire across the opening, pulling just tight enough to take out the slack,
snap the vinyl cap onto the opposing side. As the vinyl cap depresses onto the
base, the wire is pulled into the cap channel thereby stretching the wire.
No
need to worry about bending or bowing the base angle since it will be firmly
attached to the frame opening with self-drilling screws 10 inches (254
millimeter) apart (painted screws are supplied).
The ScreenEze™ System works
with all 18 x 16, 18 x 14, and 20 x 20 fiberglass screen wire.
Color: Bronze
Length: 96 in. (2.43 m)
Additional Product Information:
Angular openings are no problem, just measure the opening and miter the corners.
As an added bonus, the screen wire can be removed during the cold winter months,
and replaced with clear vinyl, to give an additional thermal break and air seal.
Note: Screen wire and clear vinyl are not included.