Eliminates Small End Plate Covering Hinge on Edge of Fixed Panel
The new style CRL Pinnacle 092 Series 90° Glass-to- Glass Hinge replaces
the old style Pinnacle 090 Series 90° Glass-to-Glass Hinge which required a
cut-out in both the door and the fixed panel. This new style requires only two
holes (per hinge) in the fixed panel, and a cut-out in the door.
Requires Holes in Fixed Panel and Cut-Out in Door
3 Year Warranty
Minimum Order: 1 Each
Additional Product Information:
After installation of the old style Pinnacle a small end plate was adhered to
the edge of the fixed panel. The new style eliminates the small end plate,
leaving a more aesthetic, uninterrupted glass edge for the fixed panel.
Standard Reversible Pivot Pin: Each Pinnacle Hinge contains a Reversible
Pivot Pin. One side of the Pivot Pin is marked at 90°; the opposite side of the
Pivot Pin is marked 85°. Standard Pinnacle Hinges come with the 90° side
activated, which brings the door to the standard closing position. Offset Models
come with the Pin pre-set for 85° (5° tighter closure into shower interior). The
Pin can be rotated (not flipped upside down) to activate the other side.
Glass Thickness: 3/8 to 1/2 inch (10 to 12 millimeter) tempered safety glass.
There are 13 standard finishes, and custom finishes are available upon request.
Templates specific to these Hinges are packed in each box, or are available by
contacting the CRL Technical Sales Department at (800) 421-6144, or by e-mail.