- Made Especially to Cut Notches in Muntin Bar Prior to Fabrication
- Air-Operated Hold Down Clamp
- 3/16" Aluminum Table Top
|
Insulated glass fabricators use the CRL Muntin Bar Router to put notches in muntin bars prior to insulating glass unit fabrication. The welded steel constructed table has a 3/16 inch (4.8 millimeter) thick aluminum top measuring 18 by 120 inches (45 by 305 centimeters). An adjustable cut-off gauge is mounted on the table to line up the muntin bars prior to routing. The router is mounted on a linear slide plate and will route a groove in a 15 inch (381 millimeter) wide gang of muntin bars. The muntin bars are held in place by a pneumatic actuated bar assembly. It comes complete with 110 volt router.