- Designed for CRL Mirror Mount System Extrusions
- Helps Prevent Mirror Backing Failure Due to Moisture Build-Up
- 12' (3.66 m) Stock Lengths
This CRL Mirror Mount System Cleat has a unique offset profile which holds a mirror away from direct contact with the wall surface, and also creates a pocket into which the Top Channel Cap or a Mirror Frame Extrusion fits. The unique offset profile of the cleat helps keep moisture from being trapped behind the mirror, while also concealing screws and support hardware. When used with a bottom FHA Type "J" Bar, and a Top Channel Cap the system affords the installer a neat, trim way to mount mirrors with a narrow (5/16 inch, 7.9 millimeter) frame.
If a fully framed system is desired use Mirror Frame Extrusion.
Hint: If using the Top Channel Cap, FHA "J" Bar system, closed ends can be created by trimming back a potion of the J-channel, and bending back the front flaps to close off the ends.
Not recommended for schools, hospitals or institutions where mirror edges should be protected on all four sides.