Paintable and Easily Cleaned Up with Soap and Water
Can be Used on Exterior or Interior Surfaces with Superior Adhesion to Building Surfaces
CRL 800 Acrylic Latex is a pure acrylic latex sealant for general purpose interior and exterior caulking in architectural applications where slight to moderate movement is anticipated. Formulated with the highest quality ingredients including a touch of silicone for greater adhesion and weatherability. Completely compatible with premium grade latex and oil based paints and will not stain adjacent surfaces. It absolutely will not stain, chalk or fade, and cures to a tough, flexible bond to most all building material surfaces.
Used for the sealing of interior and exterior door and window frames, siding and bathroom applications. The mildew resistant formulation makes it the choice in areas when moisture is present. CRL 800 seals out air infiltration, while exhibiting excellent adhesion to plaster, drywall, wood, vinyl, aluminum, steel, glass and other clean surfaces. It may be used to grout marble and ceramic tile, repair mortar joints, and under controlled conditions, to bed insulating glass units and storm windows.
In order to help you better select the correct sealant, we have put together a Silicone and Sealant Selector Chart.
Contents of Cartridge: 10.5 fl oz (310 ml)
Minimum Order: 1 Cartridge
Case qty 30pcs (price shown per 1 cartridge)
Technical Data: Exceeds the requirements of ASTM C-834-95 Specification For Latex Sealants.
Although the freezing point of CRL 800 is below 32 degrees F (0 degrees C), and the sealant can withstand five freeze-thaw cycles, for best performance protect it from severe cold and apply above 40 degrees F (4 degrees C) to lessen the possibility of frost in the joints. It may be painted within 30 to 45 minutes after application with quality grades of latex or oil paints. Water may be used to remove excess sealant from substrate and clean tools before cure, but after cure the sealant needs to be removed by mechanical means.
CRL 321 Silicone
Pecora AC-20® + Silicone
OSI® Polyseamseal Acrylic Caulk with Silicone, OSI ®SA-167 Sonneborn® Sonolac Silicone
Tremco® 834 Silicone
The sealant must be protected from water for 24 hours after application; do not caulk on the exterior when rain is imminent. For insulating glass units and storm windows, the windows must be properly weeped or entrapped water could cause reversion. Sealant must be given additional time to fully cure before windows are installed because of the closed-in conditions. Protect from freezing before fully cured. Check cartridge label and Specification Data Sheet for additional limitations.